Re: John from Australia - down under
John, go to my profile and scroll down to "My A". I made them for the rear only. They are for a Monroe (Aust. ?) Gasmatic, #59017 shock. This shock has a loop or eye at each end and is probably the easiest configuration to work with. I copied the brackets that were on my coupe. I used 2x2x1/4" angle iron 5 3/4" long, They are Right and Left, They are not duplicates. Once I cut the steel, I used only my drill press and a angle grinder. I used the grinder to cut the clearance where it interferes with the rear axle housing. I made a picture but I can't display it now.
Terry
Last edited by Terry, NJ; 08-06-2013 at 07:43 AM.
|