The Ford Barn - View Single Post

Krylon32 · 04-01-2019, 12:58 PM

I used to sell a 10 inch diaphragm pressure plate part number CA30 which had the correct pitch on the fingers and the correct inside diameter on the fingers so it didn't machine the large bearing TO hub. I believe it was for an early 50's Ford truck? They still show up from time to time but are getting a little like hens teeth. I used to get them from NAPA or Fort Wayne Clutch.

04-01-2019, 12:58 PM	#3
Krylon32 Senior Member Join Date: May 2010 Posts: 4,484	Re: Diaphragm Pressure Plate I used to sell a 10 inch diaphragm pressure plate part number CA30 which had the correct pitch on the fingers and the correct inside diameter on the fingers so it didn't machine the large bearing TO hub. I believe it was for an early 50's Ford truck? They still show up from time to time but are getting a little like hens teeth. I used to get them from NAPA or Fort Wayne Clutch.