Quote:
Originally Posted by glennpm
You're welcome David!
You need more heated volume of gas, i.e., Oxy-Acetylene which you can't get with the MAPP. It is hot enough but not enough heated volume of gas such as you can get with a rosebud. The MAPP flame would be smaller and cover less area. You need more heated air volume, 1500°F or so, over a much larger area of the pitman arm to make the bend.
Glenn
|
Do you think after it is hot enough I could bend it with a big pipe vs Banging it with a hammer?
How about MAPP and one of those spreader tips?
A friend of mine is going to loan me his oxy setup and he is borrowing a rosebud tip from his brother. He was wondering about doing it while installed on the car. He has not seen the thickness of this arm though