The Ford Barn - View Single Post - 53 Customline Front Upper Control arm clearances

53Customline · 08-08-2021, 10:04 AM

1953 supplement indicates clearance to be .0007-.018 "upper arm inner shaft and bushing.
Which side is the clearance on outside as shown in the attached photo or inside under the seal?

Question will likely be the same for the Lower control arm

Thanks
UpperControlArm-Driver-08-08-21.jpg
Randy N

08-08-2021, 10:04 AM	#1
53Customline Member Join Date: Dec 2011 Location: Raleigh,NC Posts: 32	53 Customline Front Upper Control arm clearances 1953 supplement indicates clearance to be .0007-.018 "upper arm inner shaft and bushing. Which side is the clearance on outside as shown in the attached photo or inside under the seal? Question will likely be the same for the Lower control arm Thanks UpperControlArm-Driver-08-08-21.jpg Randy N