The Ford Barn - View Single Post

Jon-Ohio · 08-08-2015, 03:23 PM

Sponsored Links (Register now to hide all advertisements)

Thanks Jeff - you answered my question in your MS thread:

Quoting Jeff from his well written MS thread:

"Service Note: Setting float height, the float should be parallel to the upper gasket surface. I used the float seam to gasket surface (15/16"). In the photo it looks a little off but this is camera distortion. If measured as shown the clearance between the gasket surface and the top of the float is 1/4". The height from the gasket surface to the bottom of the float is 1 3/4".

08-08-2015, 03:23 PM	#4
Jon-Ohio Senior Member Join Date: May 2010 Posts: 191	Re: Marvel Schebler float depth ? Sponsored Links (Register now to hide all advertisements) Thanks Jeff - you answered my question in your MS thread: Quoting Jeff from his well written MS thread: "Service Note: Setting float height, the float should be parallel to the upper gasket surface. I used the float seam to gasket surface (15/16"). In the photo it looks a little off but this is camera distortion. If measured as shown the clearance between the gasket surface and the top of the float is 1/4". The height from the gasket surface to the bottom of the float is 1 3/4".