Re: 1936 Rumble Seat Step Question
The rumble seat step plate is bolted to the top of the fender with a square washer on top that is curved to match the fender.
Under the fender is a square nut that is threaded to match the step and also curved to match the underside of the fender. I have not seen these available and would probably need to be made or some other method used to reinforce the fender.
Thanks to Don Rogers for this information.
Last edited by Gary Tosel; 03-26-2018 at 12:00 AM.
Reason: Thanks to Don Rogers for this information
|