The Ford Barn - View Single Post

allison-tech · 09-22-2011, 09:55 PM

Can the stock head be milled for better compression? If so, how far can you go? If valve clearance is an issue, could the head be milled with a slight angle? I realize, of course, it would have to be a very slight angle along with slightly elongating the holes for the head-bolts to compensate.

09-22-2011, 09:55 PM	#1
allison-tech Member Join Date: Sep 2011 Location: Huffman, Texas Posts: 41	Milling a head for compression? Can the stock head be milled for better compression? If so, how far can you go? If valve clearance is an issue, could the head be milled with a slight angle? I realize, of course, it would have to be a very slight angle along with slightly elongating the holes for the head-bolts to compensate. Last edited by allison-tech; 09-22-2011 at 10:20 PM.