The Ford Barn - View Single Post

Russ/40 · 06-10-2016, 10:20 AM

Moving the engine forward is not a viable solution in my opinion. You still have to get that special bolt out. You might as well start there. I made the tool with the square fitment. I put two flats on the sides of the tool's shaft. Good downward pressure, combined with a crescent wrench for torque, made it an easy job.

06-10-2016, 10:20 AM	#2
Russ/40 Senior Member Join Date: May 2010 Location: Santee, California Posts: 3,505	Re: Chatter Rod Removal Moving the engine forward is not a viable solution in my opinion. You still have to get that special bolt out. You might as well start there. I made the tool with the square fitment. I put two flats on the sides of the tool's shaft. Good downward pressure, combined with a crescent wrench for torque, made it an easy job.