View Single Post
Old 06-14-2019, 05:48 PM   #2
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 10,154
Default Re: How do I use this puller?

When the spark plug adapters are set good and solid, the frame will fit down on the plug studs and make contact with the cylinder hold down studs that are firmly held in the deck of the block. When you tighten the two nuts on the plug studs it applies a jacking force by pulling against he head and pushing against the head hold down studs. The big holes in the frame allow an overhead hoist or cherry picker crane to apply upward pressure as well. Something will give eventually. Hopefully they aren't too badly corroded between the head hold down studs and their corresponding bores.

They should show a photo of the thing installed on an engine so a person can get the idea of how it's supposed to work.
rotorwrench is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)