[tshancock]

Thank you all for your responses. The video was helpful as well. When the condenser is in the sleeve on the side of the coil, the screw goes through the brass hole thats on top of the sleeve and then threads into the condenser. I'm assuming, which is not a good thing, that a wire would then go from the screw to the coil stud which also will have the wire from the ignition correct? What type of eyelet for the wire would I use to make that connection from the condenser. I noticed that the brass on the inside of the condenser sleeve is about an eighth of an inch down from the top of the sleeve making it difficult to use an eyelet loop on the end of a wire for the connection.