Quote:
Originally Posted by HD Rider
I'm working on a '40 pickup rear end. The left side axle has a worn out keyway and is actually broke out at the end. The threads, bearing/seal surfaces and side gear are in good shape.
Has anyone had any luck welding up the taper and having it re-cut?
Does anyone know where I might find a replacement axle shaft?
Thanks,
Paul
|
Paul, this repair is quite possible but not cost effective. In my opinion, I'd search out either a very good (condition) used axle or a NOS axle.
To repair, the axle will need to be (re) heat treated properly. This is a process that is very costly to do correctly on a "one off" piece.