Last couple of days as I found time I have pressure washed, diesel fuel cleaned with brush, Purple power, water and wire brush on drill. I cleanded pounds of solid grease off the rear end of the 39LZ. This is what I came up with, very
red.
QUESTION for today?? I cleaned up old solid froze grease from fitting in the middle of torque tube, the fitting sticks out about 3/4" and now leaks oil, why is it leaking oil, does the fitting that lubes mid shaft bearing need repaired??? Any info appreciated.
.
Before photo of rear end
.
.
.
After clean up
.
.
.
Grease Fitting in Torque Tube
.
