Re: '29 CCPU seat shopping - what do I need?
I do not know if the CCPU is different from the RPU, but this is what we had.
We had a piece of plywood in the shape of the bottom seat spring with holes drilled in to let air out when sat upon. The seat spring is attached to the plywood base, and the padding goes on top of the spring followed by the seat cover.
The only attachment is the board I attached to the bottom of the seat base, that will "lock" into the small pieces sticking out from the front rail which prevent frontward and side to side movement.
The back portion of the seat has padding and the seat cover, and it rests on top of the bottom seat assembly, and "clips" down in the rear top.
Hopefully your CCPU set up is similar. Ed Williamson
|