Re: Poor quality transmission roller bearings
I have already restored my gearbox and have read it here. It is the next level of escalation to botch up a needle bearing. I had complained about the first scraps to a well known dealer I trusted and received immediate replacement. Now after two years, the vehicle should be registered soon. Surprise, surprise, it all starts again. These are the bearings I just read about. The picture attached shows three needles where the hole is not in the center. the needles egg on the pins. It is clear that the pins are worn out. For the sake of order, my complaint about the rear wheel bearings attached. I was lucky with the wheel bearings, 3x NOS bowers on ebay.com.
thanks for your attention
Rik
Last edited by Ford-A-baquet; 06-28-2020 at 01:50 PM.
|