The Ford Barn - View Single Post

Tim Ayers · 06-12-2020, 08:16 PM

I've never done this, but some have had good luck filling the block with Evaporust.

It would really help if you would take the head off. If you did, you could really get in deep into the water jackets with a long screw driver to scrape out the crud that settles in the back of the block.

06-12-2020, 08:16 PM	#4
Tim Ayers Senior Member Join Date: May 2010 Location: NJ Posts: 6,179	Re: Flushing engine block I've never done this, but some have had good luck filling the block with Evaporust. It would really help if you would take the head off. If you did, you could really get in deep into the water jackets with a long screw driver to scrape out the crud that settles in the back of the block.