The Ford Barn - View Single Post

burner31 · 04-13-2020, 09:13 AM

Tell us about the valve train, is it one you are making, or is it one you are adapting from another motor?
Where are the push rods coming from, made special for this engine or from another motor?
On the spark plug question I assume those will be cut in after the casting, or can't we see them from the angle of the views?

04-13-2020, 09:13 AM	#19
burner31 Senior Member Join Date: Dec 2014 Location: Shawnee, Ok Posts: 3,471	Re: My first iron OHV casting! Tell us about the valve train, is it one you are making, or is it one you are adapting from another motor? Where are the push rods coming from, made special for this engine or from another motor? On the spark plug question I assume those will be cut in after the casting, or can't we see them from the angle of the views? __________________ Keith Shawnee OK '31 SW 160-B Last edited by burner31; 04-13-2020 at 09:19 AM.