The Ford Barn - View Single Post - Rear Float-a-Motor Mount Install Issue

duke36 · 04-19-2018, 07:43 PM

There is only 1 rubber pad between the FAM outer plate and frame, no rubber pad inside the frame as shown in Brattons new redesigned kit, which fits very well. The key to the design are the new donuts ,which probably should be replaced every 5 years or so. One should compare all the vendors' kits to select a preference.

04-19-2018, 07:43 PM	#8
duke36 Senior Member Join Date: Jun 2015 Posts: 1,414	Re: Rear Float-a-Motor Mount Install Issue There is only 1 rubber pad between the FAM outer plate and frame, no rubber pad inside the frame as shown in Brattons new redesigned kit, which fits very well. The key to the design are the new donuts ,which probably should be replaced every 5 years or so. One should compare all the vendors' kits to select a preference.