The Ford Barn - View Single Post - here we go again... does anyone make 3 7/8

tubman · 11-18-2015, 08:04 PM

Walt,

Think about it. A stock Ford piston on a small journal rod will be no higher in the bore at the top of the stroke than a stock setup. With a proper offset ground crank, it will go down 1/8" lower in the cylinder.

Tubman

11-18-2015, 08:04 PM	#8
tubman Senior Member Join Date: Dec 2013 Location: Minnesota, Florida Keys Posts: 10,321	Re: here we go again... does anyone make 3 7/8 Walt, Think about it. A stock Ford piston on a small journal rod will be no higher in the bore at the top of the stroke than a stock setup. With a proper offset ground crank, it will go down 1/8" lower in the cylinder. Tubman Last edited by tubman; 11-18-2015 at 08:28 PM.