The Ford Barn - View Single Post

40cpe · 11-04-2019, 08:32 PM

If you successfully blocked the flow through the horizontal passage, you have to provide full flow through the barbed fittings you have installed. The horizontal passage was 7/16", Are those barbed fittings screwed into 1/4" pipe threads? How large is the internal ID of those fittings?

11-04-2019, 08:32 PM	#12
40cpe Senior Member Join Date: May 2010 Location: Star, MS Posts: 4,024	Re: late flathead oiling? If you successfully blocked the flow through the horizontal passage, you have to provide full flow through the barbed fittings you have installed. The horizontal passage was 7/16", Are those barbed fittings screwed into 1/4" pipe threads? How large is the internal ID of those fittings?