Quote:
Originally Posted by Ken Crans
At least before you drill the holes, check from pilot hole to see if they are equal. If not, might have some vibration. Are you going to have the flywheel reground after holes are done? Looks like it could use it... Good luck.
|
Some very light rust from the disk is all... no biggie.
Since the templates are all the same, only way they'd not be centered is if the holes for the 11 inch clutch weren't in the correct location. But you can bet we'll measure everything as good as we can. The templates were machined to a tight .315 to match the shoulder of the bolt as to keep everything centered.
I will not use these templates to do any drilling, they are only to check for proper alignment of the pressure plate holes to make sure my drawing is correct.