The Ford Barn - View Single Post

George/Maine · 01-30-2016, 10:20 AM

If you keep the 40 linkage you have to steady the end of the horz shaft.
Then get angle iron and bolt to trans 2 bolts left side.
Make parts as shown.
Don't worry about pretty you can always chrome later.
Just get it to work first.
This should work.

01-30-2016, 10:20 AM	#22
George/Maine Senior Member Join Date: May 2010 Location: Mid coast Maine Posts: 1,878	Re: 1940 Pickup clutch linkage If you keep the 40 linkage you have to steady the end of the horz shaft. Then get angle iron and bolt to trans 2 bolts left side. Make parts as shown. Don't worry about pretty you can always chrome later. Just get it to work first. This should work.