Thread: Make Your Own flathead Engine Stand
View Single Post
Old 09-07-2012, 06:54 AM   #9
HOTROD_WILLIE
Senior Member
 
HOTROD_WILLIE's Avatar
 
Join Date: May 2010
Location: Greensboro, NC
Posts: 482
Default Re: Make Your Own flathead Engine Stand
Quote:
Originally Posted by Russ/40 View Post
Again, can you install the crankshaft assembly with the block on your stand?
Yes just like a regular stand. This design is based off the design of one made back in the day. GC
HOTROD_WILLIE is offline   Reply With Quote