11-14-2020, 01:24 PM
|
#22
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,849
|
Re: Head gasket?
Quote:
Originally Posted by 1crosscut
I'm very careful to spray the copper coat from the inside out to keep the outer edge clean leaving a crisp white gasket edge. Does nothing for performance but looks nice. If you get too much copper coat on and it squeezes out leave it alone until it is dry and shave the globs off with a sharp knife or razor blade. Try it while it is wet and it will make a smeary mess all over things.
|
Just curious. When you spray copper cote on your gasket what do you do about the overhang of the gasket due to the 5.5 head being physically smaller than a stock head/head gasket? I suppose you could mask it off?
I use the Best Graphtite head gasket without sealant.
|
|
|