View Single Post
Old 10-31-2020, 11:30 AM   #3
Bored&Stroked
Senior Member
 
Bored&Stroked's Avatar
 
Join Date: Jan 2011
Location: Central Ohio
Posts: 5,009
Default Re: Pinion Location in Banjo

Hmmmmm . . . did you heat the case and freeze the pinion before reassembly? Are you the guy who assembled it?

I don't remember there being a "hard stop" in the case bore, so my guess is that the pinion was not pushed in far enough. I believe it "stops" when the pinion is all the way into the pinion snout bearing.
Bored&Stroked is offline   Reply With Quote