The Ford Barn - View Single Post

Andy · 10-30-2020, 02:05 PM

Sponsored Links (Register now to hide all advertisements)

I am planing a jig so the plate is square and have room to solder both sides. I could start a flare and then flatten it for more area. I think a good solder job would be fine.

10-30-2020, 02:05 PM	#6
Andy Senior Member Join Date: May 2010 Location: Kerrville, Tx Posts: 2,770	Re: Steering box bottom tube seal? Sponsored Links (Register now to hide all advertisements) I am planing a jig so the plate is square and have room to solder both sides. I could start a flare and then flatten it for more area. I think a good solder job would be fine.