View Single Post
Old 08-24-2012, 10:11 PM   #8
Bill in SoCal
Senior Member
 
Bill in SoCal's Avatar
 
Join Date: May 2010
Location: Claremont, CA 91711
Posts: 242
Default Re: Throttle Linkage attached to Engine

Before you remove the accelerator assembly from the car, check to see if there are any shims between the flywheel housing and the engine block where the two accelerator assembly bolts pass through and connect to the engine. Sometimes there are horseshoe looking shims placed there to help align the flywheel housing to reduce clutch chattering. Often they are stuck in place by old grease and dirt, but they are easy to dislodge.

I would replace the old assembly with a good original as suggested.
Bill in SoCal is offline   Reply With Quote