Quote:
Originally Posted by SteveB31
Seems to me the easy way to make one is buy a complete original tie rod with ends on it. Buy one die for one end. Cut the tie rod off on one end, thread it, install the end that was on it. Should I make some? I have many good used tie rods. If these would sell, I will make them. Your thoughts?
Steve @ Bert's
|
Hey Steve,
Yup, just take an original tie rod from the 'stuff' pile, clean it up ...inexpensive
Here's where the expense comes in (forgetting your time used to make). Went to a machine shop tool supplier and paid $35. for quality left hand threader. Finished product works very nicely !
You can even loan the LH tool to others to make their own. Cheap enough for one adjustable rod, but when will the LH tool ever be used again...ebay
!