The Ford Barn - View Single Post - Distribator off by one tooth

19Fordy · 01-26-2020, 04:58 PM

I have an 8BA pulley that looks similar to that shown except it has 3 reinforcing webs on the backside. One web is on each spoke. Both are narrow belt pulleys. Large pulley is 6 in. dia. Smaller pulley is 5 and 1/4. Each measurement was taken at front of each sheave. Crank hole is a tiny bit less than 1 5/16.

01-26-2020, 04:58 PM	#4
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,950	Re: Pulley casting number I have an 8BA pulley that looks similar to that shown except it has 3 reinforcing webs on the backside. One web is on each spoke. Both are narrow belt pulleys. Large pulley is 6 in. dia. Smaller pulley is 5 and 1/4. Each measurement was taken at front of each sheave. Crank hole is a tiny bit less than 1 5/16.