View Single Post
Old 03-27-2011, 08:39 PM   #9
Join Date: May 2010
Posts: 33
Default Re: T-Bird valve covers

This is about a set of early staggered bolt hole NOS Corvette valve covers but will apply Fords as well. When I took them out of the blue and white GM box there was white fuzzy corrosion on the edge that goes near the intake. I cleaned it off and was lucky no pitting had started but is dark colored in those areas. Is there anything that will get rid of the dark areas and what can I put on them to prevent this again? Maybe wax them good? Thank you, Evan
coilover is offline   Reply With Quote