The Ford Barn - View Single Post

redmodelt · 12-10-2018, 07:06 PM

Are you trying to used a sharp point or rounded? Ok, that is about all I can help with. I have only done a little brass and have found a rounded tip does a better cutting job. Carbide or high speed tool steel?

12-10-2018, 07:06 PM	#2
redmodelt Senior Member Join Date: May 2010 Location: Portland OR Posts: 6,342	Re: Babbitt Finish Boring Are you trying to used a sharp point or rounded? Ok, that is about all I can help with. I have only done a little brass and have found a rounded tip does a better cutting job. Carbide or high speed tool steel? __________________ I know the voices aren't real but damn they have some good ideas!