The Ford Barn - View Single Post

walkerlakeprinter · 08-12-2019, 01:43 PM

Well...I have the gaskets in. Cutting the 45-degree angles at the bottom were a problem. But I made it work and super-glued the ends together. Now I have to install the gasket between the hinge and the header. It looks like I need to fit it to the header first, as the ends need to be angled. Then I plan to mark where the holes need to be for the bolts. I think I will use some 3M sticky spray to hold the gasket in position while I fit the windshield in place. Open to any ideas!

08-12-2019, 01:43 PM	#15
walkerlakeprinter Senior Member Join Date: May 2010 Location: Walker Lake, Nevada Posts: 304	Re: Windshield gasket replacement Well...I have the gaskets in. Cutting the 45-degree angles at the bottom were a problem. But I made it work and super-glued the ends together. Now I have to install the gasket between the hinge and the header. It looks like I need to fit it to the header first, as the ends need to be angled. Then I plan to mark where the holes need to be for the bolts. I think I will use some 3M sticky spray to hold the gasket in position while I fit the windshield in place. Open to any ideas!