[haag1332]

I just received a very good question from a member via my email. I will answer it here.

The question was does the socket have retention capability for the ball of a 3/8 ratchet.

The answer is yes.

What we do (like a professional impact socket) is drill a radial hole through the socket in the center of one of the 3/8 drive flats in order for the user to line up the ball on the ratchet or extension in one spot keeping all other flats fully intact for maximum surface contact with the ratchet or extension.

Thank you for the question, I am sure others were probably wondering the same thing.