[jhowes]

I forgot about the two nuts on the gooseneck. A socket will fit and you can torque it down but be careful, it tends to break the goose neck if some tricks are not used. The most common that I read about is to put a paper match under the outer part of each ear of the gooseneck and tighten a little on each side until you reach the torque thqt you want. I shoot for 55# on the head nuts and 45# on the two gooseneck nuts. The head I do in sequence excfept forn the goosenek and I do the head in three steps one at 35#, next at 45#, and then the final torque at 55#. Meanwhile the gooseneck nnuts are slowly tightened in 6 or moe steps, a little aqt a time