The Ford Barn - View Single Post

Ol' Ron · 08-07-2020, 01:57 PM

ack in the dat, C&T automotive sold stroker kits for allot of engines for the flatheads there were two that were very popular 3/8 x 3/8 296ci and 3/8 x 5/16 284 ci. The cost was $195 I also ran a "Y" block 342?? not sure , but close. Never had any problems with any of them. They all came complete. Rings anrods and bearings. The "Y" block had converted the rods to full floaters. Interesting projects, learning by my mistakes.

08-07-2020, 01:57 PM	#128
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,855	Re: Let's build a drag race 8BA engine ack in the dat, C&T automotive sold stroker kits for allot of engines for the flatheads there were two that were very popular 3/8 x 3/8 296ci and 3/8 x 5/16 284 ci. The cost was $195 I also ran a "Y" block 342?? not sure , but close. Never had any problems with any of them. They all came complete. Rings anrods and bearings. The "Y" block had converted the rods to full floaters. Interesting projects, learning by my mistakes.