View Single Post
Old 08-26-2019, 08:29 AM   #6
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 12,294
Default Re: High compression head question

Sponsored Links (Register now to hide all advertisements)
With the necessary clearance for valves on the L-head designs, they would be hard pressed to get to 7.5:1. This is why folks came up with the OHV conversions back in the day and some of those still only had intake valves in the head.

Poured babbitt bearings can take as much rough housing as any but they are a lot harder to replace when they wear out.
rotorwrench is offline   Reply With Quote