Re: Briggs Window Frames
Marco -
Thanks for your response to my inquiry. Perhaps I was a little misleading in my comment about finish - I only meant to say that I have already finished woodgraining all of the interior trim. But to my point, I have one front and one rear window frame that each measure roughly 1 3/16 in width, and another front and rear window frame that each measure roughly 1 7/16 in width. As you have noted, the rear frames are indeed interchangeable, so at least I can match both width frames on the same side of the car so as not to cause attention to the differences without comparing both sides simultaneously. Both sets have the mounting set up for the nickel door pulls (and are not the stamped pulls like on the standard models). More than likely it won't be that noticeable once installed with the interior, but in the meantime, the difference in the measurements of the two widths piqued my curiosity. Thanks again -
Dick
|