View Single Post
Old 04-01-2013, 10:41 AM   #4
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,465
Default Re: Ignition switch/ steering wheel lock

Sponsored Links (Register now to hide all advertisements)
Get the drop off the tube. I drill a series of holes across the end of the pinch bolt and use a screwdriver to remove the bolt. Heat is usually required. The drop will now slide on the tube. You should be able to use a punch to move the spring loaded plunger up and remove the drop from the tube. If all fails, cut the tube right below the drop. Soak the drop in EvapoRust. It will desolve the rust and will not hurt the lock or other parts. Everything should loosen up and be fine.
Andy is online now   Reply With Quote