The Ford Barn - View Single Post

Andy · 09-13-2020, 03:23 PM

I was happy with using stock F1 studs. I also had good results using a 9/16in deep hole saw. I did not use the drill in the hole saw holder. It cut the swedges without hurting the hub. You do not need the carbide tip saw. The cheap one cut great.

09-13-2020, 03:23 PM	#4
Andy Senior Member Join Date: May 2010 Location: Kerrville, Tx Posts: 2,769	Re: 1940 Front Brake Drums I was happy with using stock F1 studs. I also had good results using a 9/16in deep hole saw. I did not use the drill in the hole saw holder. It cut the swedges without hurting the hub. You do not need the carbide tip saw. The cheap one cut great.