The Ford Barn - View Single Post

Pete pa · 06-10-2019, 08:52 PM

If you need a measurement for the carrier I have three I can measure. The gaskets thickness on the axle housing to the banjo center section adjust the ring to pinion lash but the carrier shouldn't move side to side once the axle housing is bolted together. Sounds like someone didn't preload the pinion right or didn't bend the lock washers over the nut and it came loose.

06-10-2019, 08:52 PM	#3
Pete pa Member Join Date: May 2010 Location: allison park pa Posts: 89	Re: Help with banjo rear If you need a measurement for the carrier I have three I can measure. The gaskets thickness on the axle housing to the banjo center section adjust the ring to pinion lash but the carrier shouldn't move side to side once the axle housing is bolted together. Sounds like someone didn't preload the pinion right or didn't bend the lock washers over the nut and it came loose.