[1930artdeco]

Hi All,


Two quick questions:


1) on the front shocks do I have to elongate the holes or use a dremel and open them up completely and then use a large washer for support?


2) I think it was here where I was trying to figure out what bushings I had on my PS frame bracket and people said that they had been replaced. I have a back up PS system and I need to know if the bushing set up on the idler arm is correct. My center link came with a large bushing and I need to know if I have to remove it. I am leaning towards yes, but before I destroy something I just want to confirm it.


3) also, I am assuming the short bushing gets pressed into the bracket and the long bushing goes into the Center link-correct?




Thanks,


Mike