The Ford Barn - View Single Post

Andy · 11-09-2019, 01:25 PM

I was working on a 32 axle and needed to make jig. I was surprized when the welded to the jig rods would slip off the perch boss and the spindle boss. The holes are parallel!!!
I have no farther use for the jig and would send the rods to you for cost. They are not very long so I need to think this thru.

11-09-2019, 01:25 PM	#14
Andy Senior Member Join Date: May 2010 Location: Kerrville, Tx Posts: 2,771	Re: 32 axle bent twist ? I was working on a 32 axle and needed to make jig. I was surprized when the welded to the jig rods would slip off the perch boss and the spindle boss. The holes are parallel!!! I have no farther use for the jig and would send the rods to you for cost. They are not very long so I need to think this thru.