View Single Post
Old 12-17-2014, 09:35 AM   #3
Kube
Senior Member
 
Kube's Avatar
 
Join Date: May 2010
Location: Wisconsin, USA
Posts: 6,394
Default Re: Removing door handles from a 40

You do not need to remove the lock to remove a handle. You do need to remove the screw (it's in the door jamb) though. Then, simply pull it out.
The lock cylinders can be a test in patience if the set screw is rusted in. the screw is a #8 if I recall correctly. Being that small and threaded deeply in to a sheet metal "sheath", well, if it is rusted, think "lots of patience". I typically will remove the door panel and heat the threaded "sheath" and slowly twist the set screw back and forth to remove it.
Authentic set screws had a slotted head which makes this task even more of a challenge.
__________________
"I can explain it for you. However, I can't understand it for you".
Kube is offline   Reply With Quote