View Single Post
Old 09-28-2020, 09:57 AM   #15
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 9,586
Default Re: Distributor Removal Tip Re Ignition Cable Clamp

Quote:
Originally Posted by Bob Bidonde View Post
Hi Brent,
The clamp mod is beneficial as a roadside fix to those who opt to install a spare distributor rather than to replace the points, the condenser or fiddle with a broken wire. Replacing the distributor is a common practice because it is faster and easier. I really think you know this.
Quote:
Originally Posted by Aretino View Post
I completed the modification as per Bob-A. No need to disturb the integrity of the head gasket seal. Thanks Bob.

Yeah, I guess I can change the points faster with the distributor still mounted into the cylinder head. The same with the condenser unless someone has installed a non-original heater manifold that blocks access. Even then, use one of the A&L burn-proof condenser and you won't have a problem. Adding to that, even most burned point contacts can be dressed with a file and re-gapped quicker than most hobbyists can find where they have their spare distributer stored in the car.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote