Sponsored Links (Register now to hide all advertisements)
thanks to all who replied -aswers to respondents
katy thanks: i thought i would an over head make a cross bar and use a 1000 pound winch to raise motor few inches, if this is easiest
terry thanks : have i got this straight?- the rear leaf spring can't spread as the perches and rear axle keep it from spreading [right?]
1.remove 2 u bolts,
2. jack up rear end on frame anterior to rear wheels enuf for spring to clear transverse member channel--
3. remove rear service brake rods where they attach to brake cross piece
[my car has no parking brake cross piece]
4.remove the clam shell halves that cover the u joint
5. rear radius tubes -can leave radius tubes in just support from below or will cross brake piece support it?
6. roll the rear wheels with the combination [differential/radius tubes/rear dangling rods] back ____ [how many inches?]