The Ford Barn - View Single Post - Rebuilding An 8Ba

Low-Blow · 04-14-2016, 10:53 AM

Thank you for all of the comments so far. I am going to have the block checked first and move forward from there. It was my belief from the beginning that the minimal amount of bore the better (since it will be a driver). I am glad that everyone is confirming that. I am also glad to know that the Isky 1007B will work with my stock EAB heads. Good stuff! I am very excited about this build, and will continue to post updates.

04-14-2016, 10:53 AM	#12
Low-Blow Senior Member Join Date: Apr 2016 Location: Paradise, TX Posts: 129	Re: Rebuilding An 8Ba - Tips & Suggestions? Thank you for all of the comments so far. I am going to have the block checked first and move forward from there. It was my belief from the beginning that the minimal amount of bore the better (since it will be a driver). I am glad that everyone is confirming that. I am also glad to know that the Isky 1007B will work with my stock EAB heads. Good stuff! I am very excited about this build, and will continue to post updates.