View Single Post
Old 11-03-2014, 09:30 PM   #1
bmodeltman
Junior Member
 
Join Date: Nov 2010
Posts: 28
Default 2 piece front pulley

I have a new 2 piece pulley that has the 2 tabs that line up.The seal sleeve part of it has square cut tangs on it and the pulley part is cut so it has rounded corners and doesn`t fit tight against the sleeve.There`s about an 1/8 inch gap between pulley and sleeve.Is this suppose to be this way to press them together or do I have to file the pulley tangs to fit the sleeve?
bmodeltman is offline   Reply With Quote