Thread: Clutch pedal
View Single Post
Old 07-24-2019, 09:09 PM   #22
bmodeltman
Member
 
Join Date: Nov 2010
Posts: 33
Default Re: Clutch pedal

Here's what I found out tonight. I took the trans out and checked finger adjustments. They were way off. I had them with in .002 when I started. They went out of adjustment. Just by pushing in clutch. I did tap on them after adjusting them and rechecked them. Changed plate with another new one that came with car. They both look like they came from the same place. Checked fingers on it and they were out. Didn't adjust them and had the same result. Took it back apart. Measured the dish in flywheel. It is at 1.125 deep. Tried to find spec in Les Anderson book. Didn't see it but did find standard disc is supposed to be. 340. Mine is .400. Thought maybe that.060 is making the pedal have to move down far to release the clutch. I did check the throw out bearing shaft and it is the correct one. I think I will order a rebuilt clutch and disc from Bert's tomorrow. Does this sound like a good plan.? You guys have been a tremendous help so far. A lot of good advise. Thank you.
bmodeltman is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)