View Single Post
Old 07-06-2014, 05:31 PM   #10
pooch
Senior Member
 
pooch's Avatar
 
Join Date: Sep 2010
Location: South Coast NSW Australia
Posts: 2,596
Default Re: Closed cab bed mounting points

Quote:
Originally Posted by wrndln View Post
pooch,
Do you have pictures of where the bolts are located? I can see where four bolts go (two on each side), but not the last two. The front bolt is shown in the picture below. The rear bolt I have seen goes through the hole on the end of the rear frame crossmember. The last bolt on a side I have no idea where it would go. Any help would enlighten me.
Rusty Nelson

Rusty , I just re read , you are after the rear 2 holes .

To that I dunno .

The main wood stringers end at the rear of the chassis and the tail light stalk is bolted to a separate block of wood on its own.

The rear steel just hangs in mid air out the back.

The 2 rear holes seem redundant .

Mine did come with full length stringers to add a bit of support at back, but these are not original, but I left them in .

My truck is a workhorse, not a show pony .
pooch is offline   Reply With Quote