[mccsix]

I'm 85 and still cranking on my A.
Recently ordered a wiring diagram from Synders. Its colored coded and based on a 6v pos grd,
So my 12v neg system needs a lot of adjust to the diagram to get the car to run right and not burn itself to the ground..already had fire in the wiring after ammeter posts insulation failed.
So I have emailed out to Synders, Mikes and Bert's asking for input on changes to the diagram in consideration of volt/ground differences. I've gotten back good info and I think I've made all the necessary adjustments.

Today I'm powering up all the adjusted wiring I've installed and am confident/fearful of the smoke/no smoke results. I wish I had some of you veterans nearby to give the car a once-over.
Wish me luck.