The Ford Barn - View Single Post

old28 · 04-10-2016, 10:14 PM

I am looking at building an A motor a bite like this.
.125 bore
stock stroke (steel crank)
aftermarket intake, headers
2x2 94 carb setup
mallory ign
Larger intake & exh valves
May run insert rod & main bearing (May be to costly)
6.5CR head

Hope to make 75 100 HP. What do you guys think??????
Am I on the right track or out to lunch.
I am thick skin so let me know a better way if there is.

I have a thread on the HAMB also.

04-10-2016, 10:14 PM	#11
old28 Senior Member Join Date: May 2012 Location: Camarillo, CA Posts: 288	Re: Ford Model A & B Motors I am looking at building an A motor a bite like this. .125 bore stock stroke (steel crank) aftermarket intake, headers 2x2 94 carb setup mallory ign Larger intake & exh valves May run insert rod & main bearing (May be to costly) 6.5CR head Hope to make 75 100 HP. What do you guys think?????? Am I on the right track or out to lunch. I am thick skin so let me know a better way if there is. I have a thread on the HAMB also.